In the process of using the scutcher, it is necessary to often add exclusive lubricating oil to the relevant parts for lubrication work, which is the same as the operation of automobiles and other machines and equipment, so the shaft of the equipment should be oiled? Here we give you detailed answers.

Each roller and its corresponding member inside the sdivider shaft need to be refueled, also three times a week. When the air humidity in the production workshop is below 50%, because of the effect of static electricity, the warp lift car starts to fly and breaks more. In the most serious case, it takes more than 2 hours for a 扻 to finish a factory wire shaft head. After we modified the oiling equipment on the 扻 silk fabric sapping machine, we solved the flying start problem caused by electrostatic induction. It only takes 45 minutes to install the same shaft head, which not only alleviated the labor efficiency of employees, but also improved the high efficiency.
Daily maintenance of the slitter machine: 1 scrub (press wheel, roll out shaft and wound can not have dirt). 2 Pay attention to power off when not needed. 3 Screws and wounds should be often refueled anti-rust treatment. Common problems: 1 When replacing the specifications, be sure to return the working pressure of the knife before opening the upper tool holder, otherwise it will destroy the tool head. If it is not necessary for a long time, anti-rust treatment oil or oil should be applied. 2 Raw materials are limited to paper products, many dragon, PC, PVC, ABS, and the thickness is within 250#. It can not be used to divide hard raw materials such as metal materials.
The slitter must add butter in the area of the left and right knife, and add oil three times a week. The clutch area of the feed must be lubricated. Toothless extruder screw his driven-train shaft must be buttered, then moved up and down, three times a week. The sealed rolls in the cylinder of the rechargeable battery slitter need to be cleaned and cleaned and moistened in the area of the fish's eyeball. The rolling bearing and loading rack are being refueled once every three days. In the case of refueling in the area of the discharge shaft pin, we should use the butter gun to carry out the oil injection, and clean the area of refueling before refueling. If it is the connection area of the brake pedal to carry out fuel, after filling up the oil to move him back and forth, every week to carry out three times of polishing, but also need to pay attention to cleaning.
The above is the "slitting machine shaft refueling problem" we have brought for you, I hope it can help you. Refueling the parts of the machine is mainly to play the role of lubrication, in order to ensure the effectiveness of long-term work, so it is very necessary.